通化硕抠家具有限公司

    高級檢索

    厚壁無縫鋼管縱向內壁缺陷超聲波探傷方法的研究

    Study on Ultrasonic Testing Method for Longitudinal Inner Surface Flaw of Heavy-wall Seamless Steel Tube

    • 摘要: 針對超聲波檢測時純橫波無法同時實現厚壁無縫鋼管縱向內、外壁缺陷的檢測，對無縫鋼管超聲波探傷入射角的允許范圍進行計算，理論分析純橫波和變形橫波探傷時所能檢測的無縫鋼管t/D范圍，并給出純橫波和變形橫波檢測常規外徑無縫鋼管時的壁厚范圍。分析認為：無縫鋼管t/D≤0.20時采用純橫波對內、外表面進行探傷；0.20 ∧t/D≤0.26時，應使用變型橫波進行表面探傷，可解決厚壁無縫鋼管縱向內壁缺陷檢測的難題。

       

      Abstract: Addressing the problem that in case of the ultrasonic testing,using the pure transverse wave can not at the same time perform detecting longitudinal flaws on both inner and outer surfaces of the heavy-wall seamless steel pipe,permissible range of the UT incidence angle is calculated,and the seamless steel pipe t/D ranges as detected by the pure transverse wave and the deformed transverse wave are theoretically analyzed,and also the wall thickness range of seamless steel pipes with regular O.D.as detected with the pure transverse wave and the deformed transverse wave is presented.Based on the analysis result,it is concluded that for pipes with t/D ≤ 0.20,the pure transverse wave should be used for detecting both inner and outer surface flaws,and for pipes with 0.20 ∧t/D ≤ 0.26,the deformed transverse wave should be used for surface detection so as to realize detection of longitudinal inner surface flaw of the heavy-wall seamless steel pipe.

       

      • HTML全文

    /

    返回文章
    返回