Oliver伸長率換算公式在X80管線鋼中的適用性探討
Analysis of Suitability of Oliver Elongation Reduction Formula for X80 Linepipe-purposed Steel
-
摘要: 通過對比分析Φ1 219 mm×22 mm規格X80鋼級直縫埋弧焊管的試制評價拉伸試驗結果，以考察ISO 2566-1∶1984中引用的Oliver伸長率換算公式是否適用于新一代TMCP的X80鋼級管線鋼。對比分析發現：采用Oliver伸長率換算公式，將Φ1 219 mm×22 mm規格X80鋼級直縫埋弧焊管板狀試樣伸長率換算為棒狀試樣的伸長率，其換算值大于實際試驗值，二者絕對差約為5%，相對差約為20%；Oliver伸長率換算公式不適用于新一代TMCP的X80鋼級管線鋼。Abstract: Based on a comparative analysis of the result from the tensile test as for the purpose of evaluation of trial production of the Φ1 219 mm×22 mm X80 SAWL pipe，it is judged whether the Oliver elongation reduction formula as described under Standard ISO 2566-1∶1984 is suitable for the latest generation of the TMCP X80 linepipepurposed steel.The analysis reveals that when using the said formula to converse the elongation of the plate-shaped specimen of the said pipe into that of the round bar-shaped specimen，the equivalent value is bigger than the measured test value，and the absolute difference between the two values is approximately 5%，while their relative difference is about 20%，which demonstrates that the Oliver reduction formula is not suitable for the latest generation of the TMCP X80 linepipe-purposed steel.
下載: