通化硕抠家具有限公司

    提高穿孔頂頭使用壽命的研究

    STUDIES ABOUT PROLONGING SERVICE LIFE OF PIERCING PLUG

    • 摘要: 分析了無縫鋼管穿孔頂頭的失效機制和材質改進狀況,穿孔頂頭的失效機制主要表現為塌鼻、粘鋼和開裂等。經對H13鋼穿孔頂頭進行稀土鋁合金化的實驗研究,結果表明,稀土鋁合金化可以明顯地改善H13鋼穿孔頂頭的鑄造性能,消除中心縮孔現象,細化晶粒和碳化物,降低S,P含量。穿管試驗表明,H13鋼稀土鋁合金化穿孔頂頭的使用壽命比H13鋼穿孔頂頭提高了40%。

       

      Abstract: Analyzed in the paper are the inactivation mechanism and the improvement of the matetial of the piercing plug. The said inactivation mechanism involves nose-flattening, steel pickup and cracking. Experimental research of rare earth aluminium alloying was conducted with the H13 Steel piercing plug. The experiment result shows that rare earth aluminium alloying can provides the plug such advantages as considerably improved castibility, elimination of the central porosity, fine grains and carbides as well as reduction of contents of S and P. Trial piercing operation has proven- that service life of the said H13 St. rare earth aluminium alloyed piercing plug is 40% longer than that of the H13 St. piercing plug.

       

    /

    返回文章
    返回