Д號鋼錠穿孔工藝研究
INVESTIGATION OF Д STEEL INGOT PIERCING PROCESS
-
摘要: 分析了在周期式軋管機組上用580/565mm的Д號鋼鋼錠穿制φ337mm×10~12mm套管所用φ570mm×90mm毛管時,毛管尾端產生的"三角帽"缺陷原因。通過對鋼的碳含量、鋼錠加熱時間、穿孔結束溫度和鋼錠高度的綜合研究,找出了減少毛管尾端"三角帽"缺陷的工藝措施。Abstract: The paper analyses the causes of triangular end occurrence when piercing 580/565mm steel ingot into φ570mm×90mm shell for φ337mm×10~12mm casing on pilger mill. The measures to decrease triangular ends of pierced shell are found through the comprehensive investigation on C content in steel, ingot heating time and shell temperature at outletof piercing as well as ingot height.
下載: