通化硕抠家具有限公司

    高級檢索

    液壓油缸缸筒用鋼管調質工藝的改進

    Improvement of Quenching and Tempering Process for Steel Tube for Fabrication of Hydraulic Cylinder Casing

    • 摘要: 介紹了液壓油缸缸筒用鋼管的技術條件要求,分析了原有調質熱處理工藝效果較差的原因,提出了新的調質熱處理工藝,即在調質前對鋼管采取先期完全消除應力、穩定組織的熱處理工藝,防止鋼管調質時產生變形;然后再采取調整材料綜合力學性能的調質(淬火+回火)熱處理工藝,使鋼管具有強度(硬度)高、耐磨性好、塑性強、承受壓力大、脫碳少、微變形等綜合性能優勢。采取此新工藝后,所生產鋼管滿足了液壓油缸缸筒的技術條件要求。

       

      Abstract: The technological requirements for the steel tube for fabrication of the hydraulic cylinder casing are presented. And the causes for the poor effectiveness of the previously-employed quenching & tempering treatment process for the said tube are analyzed. Based on the analysis result,a new quenching & tempering process is put forward. Following the new process,the tube is first heat treated to be fully pre-stress relieved,and have stable structure so as to prevent any deformation,when it is undergoing the quenching & tempering treatment. Then the tube is subjected to the quenching & tempering treatment to get the material’s comprehensive mechanical properties properly adjusted. As a result,the tube is generally in possession of such advantages as high strength(hardness),good wear-resistance,high plasticity,high pressure-resistance,low decarbonization rate,and slight deformation,etc. Owing to the said new heat treatment process,the tubes as made are in compliance with the technological requirements for the hydraulic cylinder casing.

       

      • HTML全文

    /

    返回文章
    返回