通化硕抠家具有限公司

    高級檢索

    Inconel 718無縫鋼管熱擠壓開裂原因分析和控制

    Investigation of Hot Extrusion-caused Cracking of Inconel 718 Seamless Steel Tube and Related Control Measures

    • 摘要: 采用SEM、EDS及光學金相顯微鏡等分析方法，對Inconel 718無縫鋼管擠壓產生的裂紋情況及開裂原因進行分析。分析認為：坯料外表面加熱溫度偏高，熱擠壓速度過高是造成擠壓開裂的原因。通過增加預熱時間、適當降低擠壓溫度、減慢擠壓速度，Inconel 718無縫鋼管批量擠壓后的表面質量良好。

       

      Abstract: Analyzed here in the essay are the cracks as occurring on the surface of the Inconel 718 seamless steel tube during the hot-extrusion process, and the causes by means of the SEM, EDS and the optical metallographic microscopy, etc.As a result, it is identified that high heating temperature on the surface of the blank and the high hot-extrusion speed lead to the said cracking.Accordingly relevant corrective actions are taken, including increasing the pre-heating time, properly reducing the hot-extrusion temperature, and slowing down the extrusion speed, which have brought about satisfactory surface quality of the Inconel 718 seamless steel tube as hot-extruded in lots.

       

      • HTML全文

    /

    返回文章
    返回