通化硕抠家具有限公司

    高級檢索

    全管體正火熱處理大直徑直縫埋弧焊管的開發

    Development of Full-length Normalization Process for Large-sized SAWL Pipe

    • 摘要: 介紹全管體正火熱處理L290N 直縫埋弧焊管的開發實踐。對熱機械軋制管線鋼鋼板經UO 制管后進行全管體正火熱處理時容易出現拉伸屈服強度降低和鋼管變形等問題進行研究。研究表明：采用C-Mn-微Nb 成分系的L290N 管線鋼，在TMCP 軋制后，獲得鐵素體和珠光體兩相組織，具有明顯的拉伸屈服平臺，正火熱處理后拉伸屈服強度明顯降低，但依然保持明顯的屈服平臺，1.0%以內的冷變形率進行冷整形基本不影響拉伸性能。通過工程實踐，批量生產了全管體正火熱處理Φ711 mm×15.88 mm 和Φ914 mm×17.48 mm 規格L290N 直縫埋弧焊管，其力學性能和幾何尺寸均滿足GB/T 9711—2017 標準及客戶要求。

       

      Abstract: Described here in the essay are the development activities associated with the full-length normalization process for the large-sized L290N SAWL pipe. Also studied are the problems of commonly-caused weakening of elongation yield strength and tube deformation as staying with the tube that is subjected to the full-length normalization treatment after being UO-formed into a tube from the linepipe-purposed steel plate as mechanically-hot rolled. The study result reveals that after TMCP rolled,the L290N linepipe-purposed steel of the C-Mn-micro Nb composition system develops both the ferrite and the pearlite 2-phase structures,having obvious elongation yield strength platform which still remains after the elongation yield strength is remarkably reduced due to the normalization treatment;and the elongation property is barely effected by the cold-shaping process with the cold deformation rate no more than 1.0%. With relevant engineering practice,the Φ711 mm×15.88 mm and Φ914 mm×17.48 mm full-length normalized L290N SAWL pipes are massively produced with all the indexes concerning the mechanical properties and geometric dimensions up to the GB/T 9711—2017 Standard and relevant customer requirements.

       

      • HTML全文

    /

    返回文章
    返回