連軋管機芯棒支撐機架改造設計

Design for Modification of Mandrel Bar Steadier of Mandrel Pipe Mill

摘要: 分析了連軋管機芯棒支撐機架的同心連桿機構；針對某連軋管機為擴大規格范圍進行改造后芯棒支撐機架無法適應改造要求的情況，通過改變主動輥支撐位置，加大主動臂長度，對芯棒支撐機架進行改造；并對改造前后的芯棒支撐方案進行仿真分析。分析結果表明：改造后的芯棒支撐機架可以很好地適應加重芯棒，滿足擴大產品規格改造的要求。

Abstract: Analyzed in the paper is the concentric linkage mechanisms of the mandrel bar steadier of the mandrel pipe mill. Addressing the problem that after a product mix expansion-aiming modification of a certain mandrel pipe mill，its mandrel bar steadier fails to meet the modification requirement，the bar steadier proper is modified by means of changing the supporting position of the drive roller，and increasing the length of the drive arm. Furthermore，a simulation analysis of the pre-modification bar supporting scheme and the post-modification bar suppor-ting scheme is performed. As a result，it is revealed that the modified bar steadier is well suitable for the heavier mandrel bars so as to meet the requirements of the product mix expansion-aiming modification of the mill line.